Installation&Commissioning
1Pull wires throughwire hole.
Loosen screw terminals, insert wires into terminal
block, then retighten screws.
2Push thePower box into the junction box.
Back cover installation
Install the thermostat about 5 feet (1.5m) above the
floor in an area with good air circulation at average
temperature.
Do not install in locations where the thermostat can
be affected by:
• Drafts or dead spots behinddoors and in corners
• Hot or cold air from ducts
• Sunlight or radiant heat fromappliances
• Concealed pipes or chimneys
• Unheated/uncooled areas such as an outsidewall
behind the thermostat
1Place Back cover over junction box, insert and
tightenmounting screws.
2 Insert the cable into connector on circuit board of
thermostat.
3Align 4 tabs on the back cover with corresponding
slots on the back of the thermostat, and then push
it until the thermostat snaps in place.
APH07CH04
-
R2000EN
